5 Tips for Preventing the Development of Mold and Mildew on Your Boat

Boating is definitely a lot of fun, and many people do it for recreation. Getting out on the water and fishing, listening to some music, or sunbathing can make you feel a lot less stressed. You might go out there with some family members, friends, or coworkers.

 You can always get replacement boat parts if any of your current ones wear out. You should also make sure you avoid mildew and mold growing on your boat, though.

 We will talk about some of the best ways to do that in the following article. 

Remove Mold and Mildew Whenever You See Them

 Though there are several methods you can utilize to stop mildew and mold from forming on your boat, it’s difficult to keep all of it off at all times. When you see it, you can usually scrub it off, though.

 There are solvents you might buy that you can spray on. Usually, you wait for the chemicals to adhere to the mildew and mold, and then you scrub them off with a rag. You might have to use something stronger, like steel wool, if the mildew or mold are gripping some parts of your boat.

 Make Sure the Boat Stays Clean

 If you clean your boat regularly, that is one of the best methods of mold and mildew prevention.

You should get in the habit of swabbing the deck and cleaning all surfaces after you’ve used the boat.

 It’s a bit of a drag, but this form of prevention will save you a lot of headaches later. You can always put on some music to make the time pass easier as you scrub.

 Use Ventilation

 You can also use ventilation to fight off mold and mildew. Closed vessels will always attract these contaminants. If you open the boat up so there’s always air flowing over and through it, you should see much less mold and mildew. It’s even more crucial to do this if you keep your boat in a very humid climate.   

You can use louvered vents and dorade boxes to help with ventilation. These are low-cost options that encourage maximum airflow on your boat.

 Watch Out for Leaks

Leaks are something else that will cause mold and mildew, so you must watch out for them. The best way to do this is to inspect your boat regularly and thoroughly.

 Go below decks and check everything before you take the boat out on the water and when you bring it back to the dock. Any leak you see should be repaired without delay.

 Keep Your Boat Dry

 Your boat probably spends much of its time in the water, and its lower portions are meant to stay wet. The upper sections should not be in a constant state of dampness, though, or you risk mold and mildew.

 You can fight this by stretching a protective covering like a tarp over the top part of your boat. You can easily buy a fitted one that matches your style of boat.